Feeds & Speeds Calculator
Spindle rpm and feed rate for turning and milling, worked out from cutting speed and tool diameter. This free version covers mild steel and brass, in HSS or carbide. Metric, no login.
Full version: 15 materials, drilling and tapping, power, cutting time and G-code for HAAS or 828D. Request access
Starting values from general machining tables. Use the tool maker's data where you have it, and check the result against your machine and set-up before cutting.
How it's worked out
- n = 1000 × Vc ÷ (π × D)
- Spindle speed in rpm from cutting speed Vc (m/min) and diameter D (mm), held to the maximum spindle speed you enter.
- vf = f × n
- Turning feed rate in mm/min from feed per revolution.
- vf = fz × z × n
- Milling feed rate in mm/min from feed per tooth and the number of flutes.
- Vc range
- Roughing starts low in the material's range; finishing runs higher with a lighter feed.
Common questions
How do I work out spindle speed for turning or milling?
Spindle speed n (rpm) = 1000 × Vc ÷ (π × D), where Vc is the cutting speed in m/min and D the work diameter (turning) or cutter diameter (milling) in mm. At Vc 200 m/min on a Ø50 bar: 200 000 ÷ 157.08 = 1273 rpm. The calculator holds the result to the maximum spindle speed you enter.
How do I work out the feed rate in mm/min?
Turning: feed rate vf = feed per rev f × rpm, so 0.25 mm/rev at 1273 rpm is 318 mm/min. Milling: vf = feed per tooth fz × number of flutes z × rpm, so 0.05 mm/tooth on a 4-flute cutter at 3000 rpm is 600 mm/min.
Should roughing run faster or slower than finishing?
Roughing starts low in the material's cutting speed range with a heavier feed; finishing runs a higher cutting speed with a lighter feed for a better surface.
What does the free version leave out?
The free version covers mild steel and brass, turning and milling, and shows rpm, feed rate and feed per rev. The full calculator adds 13 more materials, drilling and tapping, chip thinning for light milling cuts, metal removal rate, power and torque, surface finish, cutting time and speed and feed blocks for HAAS/Fanuc or Sinumerik 828D.
Can I use the numbers straight on the machine?
They are starting values from general machining tables. Use the tool maker's data where you have it and check the result against your machine, tool and set-up before cutting.